The Init Pass by floss manual

[Codesound]

@Karamel1 .. you are one most active in this forum… I’m not a guru in Csound but in this forum I have had a lot of support from users. I downloaded your sample player and I try it in this week end. thanks for sharing it.

Just to reason:

Time ago Iain wrote:

@iainmccurdy

Looking at the line:aline line 0, 1, 1024After 1 second aline is 1024, but if the note extends beyond 1 second line will continue in the direction in which it is going. After 2 seconds aline will be 2048 and so on.If you swap the line opcode for linseg, linseg will hold its final value rather than continue.Also the table pointer should go as far as 1023 not 1024; 0 is the 1st table value, 1023 is the 1024th table value so “aline linseg 0, 1, 1023” should fix it.

So, I just think what to say:

@Codesound

Whenever a Csound instrument is called, the a and i variables are set to initial values (for the k variables see later). This is called the initialization pass.

is correct…

R